Precision winding machine

Precision winding machine, servo winding machine, rewinding machine

Operation process

1、 Positioning

1. Align the center position of the machine with the center position of the wire wheel of the matched machine outlet

2. After positioning, lock the bottom universal wheel.

2、 Power on: 1. Open the rear door of the host control box, connect the RST in the lower left corner of the electrical board to the three-phase power, and connect the N to the neutral wire.

3、 Debugging 1. Check if the power supply is working properly and if the display screen is lit up.

2. Press the start button to adjust the potentiometer and check if the direction and speed control of the motor rotation are normal. If the winding motor reverses, switch the two live wires randomly until the winding motor rotates normally. The motor is experiencing weakness and slow rotation. Check if the three-phase power supply is missing phase.

3. The cable tray is a special type, and when winding a 20/30/36mm flat strip, a corresponding width of cable tray needs to be installed. Narrow wires and wide cable trays can cause material overlap on both sides of the spool.

4. The servo motor starts automatically and check if the rotation direction of the servo motor is correct.

4、 Plate installation

1. Push the spool onto the lifting device slide and press the descent button to make the center hole level with the top cones on both sides.

2. Move the wire spool towards the directional top cone to insert its top cone into the center hole, then shake the handwheel to insert its top cone into the center hole and clamp the wire spool.

3. Lift the up button of the safety control cabinet and lift the wire reel.

5、 Lead wire

1. Pass the wire head over the outermost cable reel and then through the front stainless steel cable device.

2. When using flat strips of different specifications, corresponding width stainless steel cable trays should be selected.

3. Align the wire head on the servo cable with one side of the spool, insert the wire head into the wire hole on the spool, and set the positioning origin of the servo cable

6、 Servo Description

1. The servo cable must be operated in automatic mode with the knob.

2. Servo cable reset function, click the waste wire elimination button, and the cable will return to the starting point

3. The device has a reverse function. After switching from automatic mode to manual mode, the winding motor can be operated to reverse (the reverse cable does not track)

4. In manual mode, after the servo cable moves, click the waste wire elimination button to reset the cable position.